Quote from marlonss on August 19, 2021, 2:38 amWhen using the 3D printer interface, I see the command M105 continuously sent. M105 is a temperature report request.
Noticed, the XYZ motor positions controller in the interface was "faded" out, that is not usable.
The problem is really that the computer did not connect to the 3D printer board.
I tired another port and everything is working.
When using the 3D printer interface, I see the command M105 continuously sent. M105 is a temperature report request.
Noticed, the XYZ motor positions controller in the interface was "faded" out, that is not usable.
The problem is really that the computer did not connect to the 3D printer board.
I tired another port and everything is working.